Epson DFX-9000 Service Manual page 250

Epson DFX 9000
5. From the Adjustment Program, select the
.
Adjustment
Figure 5-25. APTC Detection Position Adjustment screen
6. Click Enter adjustment mode
thickness value on the printers' LCD panel.
A P G A d j u s t P l a t n
+ X X
7. Open the top cover and move the CARRIER UNIT to the Ribbon
cartridge replacement position by hand. Then, remove the Ribbon
Cartridge.
Adjustment
APTC Detection Position
, and check the displayed paper
Software adjustment
8. Attach the Dial-Gauge part of the APG Gauge Jig to the Dummy-
Head already installed on the CARRIER UNIT, as shown.
APG PT JIG
Figure 5-26. Installing the Jigs
9. Move the Carriage by hand to each of the three measurement
positions: 11th, 68th, and 136th column, and verify that the value on
the Dial-Gauge at each location is within the allowable range.
0.39 mm ± 0.01 mm on the Left
0.39 mm ± 0.03 mm in the Center and on the Right
Revision B
APG Gauge Jig
(Dial-Gauge + Dummy-Head)
243