Epson DFX-9000 Service Manual page 197

Epson DFX 9000
6. Slowly feed the CARRIER CABLE UNIT FFC inside the printer
mechanism toward the carrier as follows: First, pull the FFC from
the bottom of the mechanism outside through the hole near the
bottom of the SIDE FRAME, RIGHT. Then, feed the cable in
toward the carrier through the hole in the frame beneath the upper
cable clamp. See Figure 4-72.
6)-2
Feed the FFC inside the printer.
CARRIER CABLE UNIT
Figure 4-72. CARRIER CABLE UNIT Removal (2)
7. Remove the two C.P. (S-P1) 2.5 × 8 and one C.F. 2.5 × 4 screws that
secure the Carrier holder to the CARRIER UNIT using a Phillips
No.1 screwdriver.
8. Lift the front side of the carrier holder. Disconnect the CARRIER
CABLE UNIT from the connector on the Carrier PCB, and then
remove the Carrier holder.
ASY, p. 153.
Disassembly and Assembly
6)-1
Pull the FCC out of the printer.
Refer to section 4.2.4.3 CARD GUIDE
9. Release the two tabs that secure the cable cover of the CARRIER
CABLE UNIT to the Carrier holder, and remove the CARRIER
CABLE UNIT.
9)-1
CARRIER CABLE UNIT
Figure 4-73. CARRIER CABLE UNIT Removal (3)
CARRIER CABLE UNIT
7)
C.P. (S-P1)
7)
C.F.
Tabs
9)-2
Revision B
Carrier holder
190