Epson DFX-9000 Service Manual page 204

Epson DFX 9000
8. Remove the PJS HOLDER ASY from the PJS ROLLER.
9. Move the CARRIER UNIT to the right side of the PR MECHA
ASY, and remove Nip shaft F together with the three Nip spring
holders F, 3 Nip springs, PJS HOLDER ASY, and the PJS spring.
Match the straight legs of the Nip Springs F and the PJS
spring with the grooves of the 3 Nip spring holders F
and the PJS HOLDER ASY (2 each).
Face the L-shaped legs of the Nip Springs F and the
PJS spring to the front side of the PR MECHA ASY,
and match the ribs (2 places each) and notches of the
Nip spring holders F and the PJS holder spring.
Route the PJS sensor cable as shown in
Disassembly and Assembly
[Front]
Figure 4-81
Sensors
Nip Shaft F
9)-2
9)-1
Nip Spring F
PJS HOLDER
ASY
Nip Spring
Holder F
Straight legs
Reassembly
PJS Sensor
Cable
Rib
Notch
Figure 4-81. PJS HOLDER ASY Removal (2)
Revision B
PJS Spring
8)
PJS Roller
[Front]
L-shaped
legs
197