Epson DFX-9000 Service Manual page 235

Epson DFX 9000
3. Insert three sheets of paper into the gap between the card guide and
the platen as shown in Figure
against the paper. Then, secure the card guide in position by
tightening the two screws.
4. Refer to Figure 5-9 and verify that three sheets of paper fit in a gap
between the platen and the card guide, but four will not fit. If the gap
is not correct, repeat from the step 3.
Figure 5-8. Card Guide Mount Position Adjustment
Adjustment
5-8, and lightly push the card guide
Card Guide
Paper
Paper
(3 / 4 sheets of 1P/55Kg paper)
Pass : Paper = 3 sheets
(The paper passes through the edge
of opening of the card guide.)
Hardware adjustment
Lightly insert the paper into a gap.
(between the card guide and the platen)
Stop : Paper = 4 sheets
(The paper stops at the edge
of opening of the card guide.)
Figure 5-9. Judging the Gap Level
Revision B
228