To Extend And Retract Axles; Operation From Ground; To Position Platform; Operation From Platform - Genie Z-135/70 Operator's Manual

Operator's Manual
Operating Instructions

To Extend and Retract Axles

1 Turn the key switch to platform control.
2 At the platform controls, press down the foot
switch and move the drive control handle in
either direction. Activate the extend axle
function or the retract axle function. Move the
switch or push the button.
The indicator light will flash while the axles are
moving and stay on when the axles are fully
extended or retracted.
The axles can only be retracted if the primary and
secondary booms are fully lowered and retracted
and the platform is between the circle-end wheels.

Operation from Ground

1 Turn the key switch to ground control.
2 Pull out the red Emergency Stop button to
the on position.
3 Start the engine.
48

To Position Platform

1 Push and hold a function enable/speed select
button.
2 Push the appropriate function button according
to the markings on the control panel.
Drive, steer and axle functions are not available
from the ground controls.

Operation from Platform

1 Turn the key switch to platform control.
2 Pull out both ground and platform red
Emergency Stop buttons to the on position.
3 Start the engine. Do not press down the foot
switch when starting the engine.
To Position Platform
1 Press down the foot switch.
2 Slowly move the appropriate function control
handle or toggle switch or press the appropriate
button according to the markings on the control
panel.
Z-135/70
Second Edition · Fourth Printing
Part No. 114474