Genie Z-135/70 Operator's Manual page 8

Operator's Manual
General Safety
Safety signs and locations
WARNING
Bodily Injury Hazard
Failure to use pipe cradle assembly according to instructions and safety rules
below and in operator's and responsibilities manual could result in death or
serious injury.
Do not exceed rated platform capacity. Secure load to platform.
Pipe cradle assembly and weight in pipe
Do not obstruct entrance/exit of platform.
cradles will reduce rated platform capacity
Do not obstruct ability to operate platform
and must be factored into total platform
controls or Emergency Stop button.
load.
Do not operate unless you are adequately
Pipe cradle assembly weighs 25 lbs (11kg).
instructed and are aware of all hazards
Maximum capacity of pipe cradle assembly
associated with movement of platform
is 200 lbs (91 kg).
with overhanging load.
Weight of pipe cradle assembly and load in
Do not cause a horizontal force or side
pipe cradles may limit maximum number of
load to machine by raising or lowering a
occupants in platform.
fixed or overhanging load.
Center load within perimeter of platform.
WARNING
Bodily Injury Failure to use panel cradles according to instructions and safety rules
Hazard below and in operator's and responsibilities manual could result in death
or serious injury.
Do not exceed rated platform Weight of panel cradles and load Do not cause a horizontal force
capacity. Combined weight in panel cradles may limit or side load to machine by
of cradles, panels, maximum number of occupants raising or lowering a fixed or
occupants, tools and any in platform to one person. overhanging load.
other equipment must not
Secure cradles to platform. Maximum vertical height of
exceed rated capacity.
Secure panel(s) to platform panels: 4 ft / 1.2 m
Panel cradle assembly railing using straps provided.
Maximum wind speed:
weighs 30 lbs / 13.6 kg.
Do not operate unless you are 15 mph / 6.7 m/sec
Maximum capacity of panel adequately instructed and are
Maximum panel area:
cradles is 250 lbs / 113 kg. aware of all hazards associated
32 sq. ft / 3 m
with lifting panels.
6
72875 C
2
DANGER
• Stop all movement.
Tip-over Hazard
If tilt-alarm
sounds, unit is on • Read operator's
a severe slope. manual before
Death or serious attempting to move
injury will result. machine.
Z-135/70
Second Edition · Fourth Printing
3
Platform uphill:
1 Lower primary boom.
2 Retract/lower secondary boom.
3 Retract primary boom.
3
Platform downhill:
1 Retract primary boom.
2 Retract/lower secondary boom.
3 Lower primary boom.
133236 A
Part No. 114474