Test Emergency, Auxiliary Controls; Test Aircraft Protection Package - Genie Z-135/70 Operator's Manual

Operator's Manual
Inspections
76 Retract the primary boom to the stowed position.
77 Raise the secondary boom to 5° above
horizontal.
78 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 1 foot / 30 cm per second.
Note: The machine will travel 40 feet / 12 m in 40
seconds.
79 Lower the secondary boom to the stowed
position.
80 Extend the jib boom 1 foot / 30 cm.
81 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the jib boom extended should not exceed 1
foot / 30 cm per second.
If the drive speed with the primary or secondary
boom raised or extended or the jib boom extended
exceeds 1 foot / 30 cm per second, immediately
tag and remove the machine from service.
82 Extend the primary boom 4 feet / 1.2 m.
83 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the jib boom extended and the primary
boom extended should not exceed 6 inches / 15
cm per second.
If the drive speed with the jib boom extended and
the primary boom extended exceeds 6 inches /
15 cm per second, immediately tag and remove the
machine from service.
84 Retract the primary boom and the jib boom.
38
Test Emergency/Auxiliary Controls
85 Push in the red Emergency Stop button to the
off position to shut off the engine.
86 Pull out the red Emergency Stop button to
the on position.
87 Press down the foot switch.
88 Activate the emergency/auxiliary controls. Move
and hold the switch or push and hold the button.
Activate each function control handle, switch or
button.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate.
Test Aircraft Protection Package (if equipped)
89 Move the gray bumper at the bottom of the
platform 4 inches / 10 cm in any direction.
90 Activate each function control handle or toggle
switch or button.
Result: All boom and steer functions should not
operate.
91 Activate the function override. Move and hold
the switch or push and hold the button.
92 Activate each function control handle or toggle
switch or button.
Result: All boom and steer functions should
operate.
Z-135/70
Second Edition · Fourth Printing
Part No. 114474