Genie Z-135/70 Operator's Manual page 34

Operator's Manual
Inspections
8 Push and hold a function enable/speed select
button and press the secondary boom raise/
extend button.
Result: The secondary boom should not raise.
On the LCD screen, the arrow next to the
extend axle symbol will flash. The secondary
boom should not raise unless the axles are
extended.
9 Push and hold a function enable/speed select
button and press the primary boom extend
button.
Result: The primary boom should not extend. On
the LCD screen, the arrow next to the extend
axle symbol will flash. The primary boom should
not extend unless the axles are extended.
10 Push and hold a function enable/speed select
button and push the turntable rotate left button.
Result: The turntable should rotate 15° and then
stop. The turntable should not rotate more than
15° unless the axles are extended.
11 Push and hold a function enable/speed select
button and push the turntable rotate right button.
Result: The turntable should return to center,
rotate 15° to the right and then stop. The
turntable should not rotate more than 15° unless
the axles are extended.
32
12 Turn the key switch to platform control. At the
platform controls, press and hold the foot switch
and move the drive control handle in the forward
direction.
13 Activate the extend axle function.
Result: The machine should drive and the axles
should extend. The indicator light will flash while
the axles are moving and stay on when the
axles are fully extended.
14 Return to the ground controls. Turn the key
switch to ground control.
15 Push and hold a function enable/speed select
button and push the primary boom up button
and then the primary boom down button.
Result: The primary boom should raise and
lower normally.
16 Push and hold a function enable/speed select
button and push the secondary boom raise/
extend button and then the secondary boom
lower/retract button.
Result: The secondary boom should raise and
extend and retract and lower normally.
17 Push and hold a function enable/speed select
button and push the primary boom extend
button and then the primary boom retract button.
Result: The primary boom should extend and
retract normally.
18 Push and hold a function enable/speed select
button and push the turntable rotate left button
and then the turntable rotate right button.
Result: The turntable should rotate normally.
Z-135/70
Second Edition · Fourth Printing
Part No. 114474