Test The Machine Functions; Test Emergency/Auxiliary Controls; Test The Tilt Sensor - Genie Z-135/70 Operator's Manual

Second Edition · Fourth Printing

Test the Machine Functions

19 Do not press and hold a function enable/speed
select button. Attempt to activate each boom
and platform function button.
Result: No boom and platform functions should
operate.
20 Press and hold a function enable /speed select
button and activate each boom and platform
function button.
Result: All boom and platform functions should
operate through a full cycle. The descent alarm
(if equipped) should sound while the boom is
lowering.

Test Emergency/Auxiliary Controls

21 Push in the red Emergency Stop button to the
off position to turn off the engine.
22 Pull out the red Emergency Stop button to the
on position.
23 Simultaneously push and hold the
emergency/auxiliary power button
and push each boom function button.
Note: To conserve battery power, test
each function through a partial cycle.
Result: All boom functions should operate.
24 Start the engine.
Part No. 114474

Test the Tilt Sensor

25 Push one of the LCD
screen control buttons until
TURNTABLE LEVEL
SENSOR X-DIRECTION
appears.
Result: The LCD screen should display the
angle in degrees.
26 Push one of the LCD screen control buttons until
TURNTABLE LEVEL SENSOR Y-DIRECTION
appears.
Result: The LCD screen should display the
angle in degrees.
27 Push one of the LCD screen control buttons until
PLATFORM LEVEL SENSOR DEGREES
appears.
Result: The LCD screen should display the
angle in degrees.
Z-135/70
Operator's Manual
Inspections
33