Assembling Accessories And Options; Installing/Removing Self-Propelling Wheels - Invacare Aquatec Ocean Ergo User Manual

1. Insert the pin of the clip G from the outside into the
required hole on the footrest B. Make sure the clip
engages around the tube.
2. Push the footrest into the guide H at the front of the
side part until the pin of clip G engages in the groove
A. The footrest can no longer be turned to the side.
The assembly procedure is the same for the right
and the left footrest.
Adjusting the Height of the Footrests
The footrests can be shortened if required (refer to
the service manual). Shortening the footrests must
be performed by a qualified technician.
1. Slightly pull up the footrest B.
2. Pull the clip G out of the hole in the footrest and
re-insert it into the required hole. Pull out the footrest
slightly further if necessary.
3. Push down the footrest until the pin of clip G engages
in the groove A.
4. Set the other footrest to the required height as
described.
Adjusting the Inclination of the Foot Plates
The inclination of the foot plates can be adjusted
infinitely variably.
1. Loosen the Allen screw C on the foot plate using a size
4 Allen key.
2. Turn the foot plate D to the required position.
3. Re-tighten the Allen screw.
1652072-A

4.3 Assembling Accessories and Options

WARNING!
Risk of injury
– The assembly of accessories and options must
be carried out according to the corresponding
instructions.

4.3.1 Installing/Removing Self-Propelling Wheels

NOTICE!
– When the self-propelling wheels are fitted,
the rear castors must remain locked to avoid
collision between castor and wheel.
– The hubs and the parking brakes for the
self-propelling wheels must be fitted by a
qualified technician.
Setup
17