Sensor (Media Eject Clamp Hp) Removal - Lexmark W850n Manual

Sensor (media eject clamp HP) removal

1.
Remove the rear upper cover. See
2.
Remove the upper media bin assembly. See
3.
Remove the two media eject unit springs attached to the media eject unit assembly by pushing them
downward.
4.
Remove the media eject clamp motor assembly. See
page 4-66.
5.
Release the hooks of the sensor (media eject clamp HP) (A) from the bracket (B).
6.
Remove the sensor (media eject clamp HP) (A).
"Rear upper cover removal" on page
Right
Springs
B
A
B
"Upper media bin assembly removal" on page
"Media eject clamp motor assembly removal" on
4024-110
4-24.
4-20.
4-67
Repair information