Programmable Knobs Mode; Multichannel Volume Knobs - E-Mu PX-7 Owner's Manual

O O O O
Turning a knob while in
this screen automatically selects
that knob for programming!

Programmable Knobs mode

If the "Programmable Knobs" parameter in the Controllers menu is set to
"Ext," or "Both," the system sends MIDI controller messages when you turn
the Controller knobs. Each knob can be programmed to send on any MIDI
channel (01A-16B) and on any continuous controller number from 1-95.
The knobs only generate a message when you move a knob to a new value.
The Controller Knob LEDs always remain off in this mode.
To Program the Programmable Knobs
Press the Controllers button. Its LED will illuminate.
1.
Turn the data entry control to select the Programmable Knobs screen.
2.
K1
Knob #
Ctrl: 22
Use the left/right cursor controls to select the fields.
3.
Select the MIDI Continuous Controller number, the MIDI channel, and
4.
Internal/External or Both for each of the 16 knobs.
Save the Multisetup if you want to save these settings. See page 147.
5.

Multichannel Volume Knobs

In this mode, each of the 16 knobs will control MIDI Channel Volume for
the like-numbered channel. This directly edits the value shown on the
preset select screen and is equivalent to sending MIDI cc#7.
CH VOLS
01A:098
View Mode must be set to "MIX" in order to see the display shown above.
When "Knobs MIDI Out" in the MIDI menu is enabled, any knob change
will send MIDI cc#7 to the MIDI out port as well as controlling the internal
channel volume.
In this mode, the LEDs next to the sixteen knobs blink to indicate MIDI
activity on the same numbered MIDI channel (from the sequencer or
external MIDI sources).
PROGRAMMABLE KNOBS
Ch:01A
CC# MIDI Chan
Basic Operations
Real-time Controller Knobs
Ext
Int/Ext/Both/Seq
PX-7 Owners Manual 37