Sound Authoring - E-Mu PX-7 Owner's Manual

Sound
Authoring
Copy User Bank
to Flash
_ _ _ _
If there is no Flash SIMM
in the unit, the error message,
"Requires Flash SIMM" will be
displayed.
292 E-MU Systems
This is a special purpose function to be used with the Flash sound
authoring feature. Flash Sound SIMMs created on an EOS Ultra sampler can
be used as a custom PX-7 bank. Presets are then created in a User bank.
When the bank of presets is finished, it can be copied, using this function,
to the Flash SIMM. Flash SIMMs contain two separate memory locations.
One of these memories contains the sound samples and the other memory
can hold four banks of 128 presets.
WARNING: dangerous voltages are exposed inside PX-7! Make sure
power is completely disconnected from PX-7 before removing the top
panel. Replace the top panel before restoring power to the unit. The two
sound SIMM sockets in PX-7, marked 0 and 1, are located behind the
controller knobs on the circuit board.The destination Flash SIMM must
be placed in SIMM socket 1.
COPY USER BANK TO FLASH
From: User
To Copy a User Bank to Flash
Make sure a Flash SIMM is inserted into the extra SIMM socket.
1.
Press the Save/Copy menu button.
2.
Rotate the data entry control to select the "Copy User Bank" function
3.
shown above.
Move the cursor to the "From" field and select the User bank that you
4.
want to copy to the Flash SIMM.
Move the cursor to the "To" field and select the Flash bank that you
5.
want to contain the User bank.
Press Enter. The Enter LED will flash and the screen below appears.
6.
Press ENTER to Overwrite
Flash SIMM Presets
Press Enter again to confirm. The following screen appears:
7.
COPYING USER BANK TO FLASH
Done. Please Reboot Now.
The Flash presets cannot be used until PX-7 is rebooted (power off then
8.
on). Reboot the PX-7 and verify that the new Flash bank has been
properly copied.
0
To: Flash
Save/Copy Menu
Copy Song
2