E-Mu PX-7 Owner's Manual page 360

   
ROMs can be installed in
any available SIMM location.
The physical position of the
sound set does not affect the
order that they appear in the
LCD.
348 E-MU Systems
Install a New ROM SIMM
Ground yourself by touching a grounded object, then remove the
1.
memory SIMM modules from the static protected packaging.
Notice that one end of the SIMM connector is notched. This notch
2.
should be oriented towards the rear panel of the unit. When installing
multiple SIMMS, install the SIMM into the lowest numbered socket first
(i.e. first CN-5, then CN-6, then CN-7, then CN-8).
2. Tilt the SIMM up
so that both tabs
click and lock the
SIMM into place.
Gently set the SIMM deep into the SIMM socket at a 45º angle with the
3.
notch toward the rear of the unit. Without forcing the insertion, let the
board rest in the socket as deep as it will go. It should rest naturally in
place at this 45° angle. Refer to the diagram on the previous page.
While applying a slight downward pressure on the top of the SIMM to
4.
keep it from popping out of the socket, tilt the SIMM board into a
vertical position. You should hear an audible click. Make sure both sides
of the silver tabs have latched.
Reassemble the Unit
Lift the top panel into a vertical position so you have some slack on the
5.
ribbon cables.
Press on the ribbon cable connectors to ensure they are properly seated
6.
before closing the unit.
Replace the top panel and all eight screws. The screws are all identical.
7.
Make sure to replace all eight screws or grounding problems could
result.
Notch
1. Set SIMM into
Appendix
Installing Sound SIMMs
socket with the
notch toward rear
of unit.