Midi Footswitch Assign; Tempo Controller - E-Mu PX-7 Owner's Manual

MIDI Footswitch
Assign

Tempo Controller

Like the MIDI Controllers, you can assign three MIDI footswitches to MIDI
footswitch numbers. Footswitches numbers are from 64-79. Destinations
for the footswitch controllers are programmed in the PatchCord section of
the Preset Edit menu. The rear panel footswitches 1 & 2 are connected to
footswitch controllers 1 & 2 in this screen. Pressing a footswitch transmits
on the MIDI controller number programmed here. Footswitch 3 routes
incoming MIDI footswitch data to the PatchCord section of PX-7.
FOOTSWITCH CONTROLLER #
1: 64
This function allows a MIDI controller to change the Base Tempo of the
Master Clock. The Master Clock is used by the sequencer, arpeggiators,
clock divisor PatchCords, tempo-based envelopes and synced LFOs. (See
"Clock Modulation" on page 176.) You can assign any controller number
from 0-31, mono key pressure, or the Touchstrip to change the Global
Tempo.
A different controller can be used to change the tempo up or down. The
Touchstrip can be assigned to both the up and down parameters to vary the
tempo up and down from a single controller. If any other controller is
assigned to both the up and down parameters, PX-7 redefines the center of
the controller's range as zero (so it acts like a pitch wheel).
MIDI Controller values are added to the Base Tempo with a range of ±64.
When the controller is set to "off" the tempo returns to its original setting.
Controllers are only recognized on the selected MIDI channel, unless PX-7
is in Omni mode, in which case all channels are accepted. This control has
no effect when using an external clock.
TEMPO CONTROLLER#
Up: 03
2: 65 3: 66
Down: 09
Controllers Menu

MIDI Footswitch Assign

CHAN
16B
PX-7 Owners Manual 143