Mitsubishi 1989-1993 GALANT Service Manual page 858

Outer dust seal
1110011
Inner dust seal,
Outer dust seal
FRONT AXLE - Drive Shaft
SERVICE POINTS OF REASSEMBLY
10. INSTALLATION OF CENTER BEARING
(1) Apply multipurpose grease to the center bearing and
inside the center bearing bracket.
(2) Use the special tools to press-fit the center bearing into
the center bearing bracket.
11 LOO10
(1) Apply multipurpose grease to the rear surfaces of all
dust seals.
Inner dust seal
Outer dust seal
(2) Use the special tools to install the dust seal so that its
surface runs even with that of the center bearing
bracket.
(3) Apply multipurpose grease to the lip of each dust seal.
NOTE
When applying grease, make sure that it does not adhere to
anything outside the lip.
4-6 g (.14-.21 oz.)