Mitsubishi 1989-1993 GALANT Service Manual page 1161

SERVICE BRAKES - Anti-lock Braking System Troubleshooting
With the ignition key in the "ON" posi-
tion, do other warning lights illuminate?
Yes
Turn the ignition switch OFF an
check.
Is the ABS warning light normal? (Check
for burned bulb.)
Yes
Is there continuity between terminals No.
8 and 4" or 17'2 on the combination
meter side?
Are instrument panel wiring harness,
body wiring harness and ABS wiring
harness connectors connected properly?
I
Yes
Broken wire in ECU, valve relay or both
drive circuits. Check and repair both
circuits.
NOTE
l
*: Non-Turbo <M/T>
Check fuse No. 9. If it is
blown, correct the cause of
the blown fuse and then
replace the fuse.
Remove the combination
meter, and check with
the ignition key "ON".
Does voltage between har-
connector terminal
No. 8 and ground indicate -
battery voltage?
Circuit in combination meter
is broken.
N o -
meter
No
. Connect connectors firmly.
bent, repair as needed.)
Revision
TSB
No
The harness between the
combination meter from
fuse No. 9 is broken.
Yes
Repair harness.
bination meter.
light bulb.
nation meter
I