Mitsubishi 1989-1993 GALANT Service Manual page 1057

ACTIVE-ELECTRONIC CONTROL SUSPENSION - Lateral Rod
1989 models
From 1990 models
Lateral rod
mounting bolt
I Axle beam
Bracket left edge surface
Bolt centre
SERVICE POINTS OF REMOVAL
1. REMOVAL OF REAR HEIGHT SENSOR ROD
NOTE
If anything other than the rear height sensor rod mounting
bolt are removed, the height sensor installation dimension
must be readjusted so remove other parts only when
absolutely necessary.
INSPECTION
Check lateral rod for damage and deformation.
l
Check each bushing for cracks, deterioration and wear.
l
LATERAL ROD BUSHING REPLACEMENT WUEAA
(1) Drive out the lateral rod bushing using the special tools.
(2) Press in the bushing using the special tools so that the
amount of projection is equal at the left and right.
SERVICE POINTS OF INSTALLATION
7. INSTALLATION OF LATERAL ROD MOUNTING BOLT
(AXLE BEAM SIDE)
Install the lateral rod mounting bolt from the direction
shown in
2. ADJUSTMENT OF REAR HEIGHT SENSOR BRACKET
MOUNTING BOLT
Move the height sensor bracket so that the display
dimensions assume the standard values, then secure the
bracket in place with the height sensor bracket mounting
bolts.
Standard value (L): 315&l mm (12.4k.04 in.)
TSB Revision
illustration.
the