Mitsubishi 1989-1993 GALANT Service Manual page 819

Spacer
Lower
PROPELLER SHAFT - Propeller Shaft
Do not lower rear end of the vehicle as the oil will flow
2.
out of the transfer.
Be cautious to
3.
transfer.
Use the special tool provided as a cover to prevent the
4.
entry of foreign objects into the transfer.
INSPECTION
Check the sleeve yoke, center yoke and flange yoke for
l
wear, damage or cracks.
Check the propeller shaft yokes for wear, damage or
l
cracks.
Check the propeller shaft for bends, twisting or damage.
l
Measure the propeller shaft runout with a dial indicator.
l
Limit:
Front propeller shaft
Center
Rear propeller shaft
NOTE
Set the V-blocks as much as possible to the end of the
shaft. Measure deflection at the center of the shaft.
Check the universal joints for smooth operation in all
l
directions.
Check the'center bearing for smooth movement.
l
Check the center bearing mounting rubber for damage or
l
deterioration.
SERVICE POINTS OF INSTALLATION
3. INSTALLATION OF SPACER/P. INSULATOR
install spacers and insulators as indicated in the illustration.
Caution
When installing the center bearing, assemble the same
spacers as removed from it (or new spacers of equal
thickness).
1060012
avoid
damage to the oil seal lip of the
mm (.024 in.) or less
0.6
mm (.024 in.) or less
propeller shaft
0.6
mm (.024 in.) or less
0.6