Mitsubishi 1989-1993 GALANT Service Manual page 1062

ACTIVE-ELECTRONIC CONTROL SUSPENSION - Reserve Tank
Air tube
Joint assembly
Grommet
Install to the body beforehand
SERVICE POINTS OF REMOVAL
5. REMOVAL OF AIR TUBES
(1) Push the special tool inward, in direction 0 shown in the
figure, in order to expand the tabs of the joint.
(2) Pull out the air tube, together with the special tool, in
direction 0.
Caution
To prevent dust, dirt and other foreign material from
getting into the air tubes, dryer or solenoid valve
openings, use vinyl tape or similar material to cover
these openings.
7. REMOVAL OF RESERVE TANK
(1) Remove the splash shield's installation clips (shown in
the figure) and the bolt.
Note that the clips should be removed by the proce-
dures described below.
push the pin at the center of the pin inward about 2
mm (08 in.).
NOTE
Do not push the pin in more than necessary, because
the grommet may be damaged or the pin may fall
inside if pushed too much.
(2) Remove the reserve tank installation nut, and then,
taking care not to damage the air tube, remove .the
reserve tank.
INSPECTION
For detailed information concerning the checking of the return
pump, the high-pressure switch and the low-pressure switch,
refer to the troubleshooting guide and service adjustment
procedures section.
SERVICE POINTS OF INSTALLATION
7. INSTALLATION OF RESERVE TANK
(1) Install the tank holders to the body.
(2) Install the reserve tank to the tank holders, taking care
not to damage the air tube.
TSB Revision