Mitsubishi 1989-1993 GALANT Service Manual page 1059

ACTIVE-ELECTRONIC CONTROL SUSPENSION - Z%iZky8"d
mounting bolt or nut
mounting bolt
rod
13. Shock absorber mounting bolts
14. Trailing arm mounting bolts
72-87 ft.lbs.*
VOTE
SERVICE POINTS OF REMOVAL
13. REMOVAL OF SHOCK ABSORBER MOUNTING
TORSION AXLE AND ARM ASSEMBLY
(1) Jack up the torsion axle and arm assembly in order to
raise it slightly.
Caution
1. Always insert a wooden block between the jack
receptacle and the axle beam and place the jack
at the centre of the axle beam.
2. Make sure that the jack does not contact the
lateral rod.
(2) Remove the shock absorber mounting bolts and the
trailing arm mounting bolts.
axle and arm assembly.
INSPECTION
Check the trailing arm and axle beam for deformation or
l
damage.
Check the torsion bar for damage.
l
TSB Revision
17-26 Nm
12-19 ftlbs.
(1989 models)
(From 1990 models)
72-87 ft.lbs.*