Mitsubishi 1989-1993 GALANT Service Manual page 1089

34-8
REAR SUSPENSION <FM/D> - Rear Suspension Assembly
BUSHING REPLACEMENT
TRAILING ARM BUSHING
Caution
The bearing within the special tool should be installed,
as shown in the figure, at the race surface nut side of
the bearing.
(2) Press the bushing with the special tool into the trailing
arm (from the chamfered part of the trailing arm) so that
the bushing hole is at the position indicated in the figure.
(3) Be careful that the bushing hole is at the position indicated
in the figure and that the difference in bushing projection
distances does not exceed the following value.
LATERAL ROD BUSHING (BODY SIDE)
(2) Press in the bushing using the special tool so that the
amount of projection is equal at the left and right.
The replacement of the lateral rod' bushing at the axle
beam side is made by the same procedures described in
steps (1) and (2) above.
TSB Revision