Mitsubishi 1989-1993 GALANT Service Manual page 542

AUTO-CRUISE CONTROL SYSTEM
Adjusting nut B
Throttle cable
Throttle
Adjusting nut D
cable
Throttle Lock nut/ Adjusting nut B
Stopper
(1) Remove the link protector. (Refer to P.13-402.)
(2) Check that there are. no sharp bends and breaks in the
accelerator cable, throttle cable and auto-cruise control
cable.
(3) Turn the ignition switch to the ON position (without starting
the engine) and leave in that condition for approximately 15
seconds.
(4) Leave plenty of play in each cable and temporarily install
adjusting nuts A, B, C and adjusting bolts D.
(5) Adjust with adjusting nut A so when link A hits the stopper,
Stopper
the accelerator cable play (inner cable play) reaches the
standard value.
Standard value
M / T : O - l m m (O-.04 in.)
A/T: 2-3 mm (.08-.12 in.)
(6) Fix the accelerator cable with the lock nut.
(7) Adjust with adjusting nut B so when link B hits the stopper
of link C, throttle cable play (inner cable play) reaches the
standard value.
Standard value: l-2 mm (&I-.08 in.)
(8) Fix the throttle cable with
(9) Adjust with adjusting nut C so when the link C stopper hits
the end of link B, the auto-cruise control cable play (inner
cable play) reaches the standard value.
Standard value: l-2 mm (.04-.08 in.)
(1 l)After adjusting, confirm that throttle valve fully opens and
closes by operating pedal.
lock nut and adjusting bolt D.