Mitsubishi 1989-1993 GALANT Service Manual page 1052

ACTIVE-ELECTRONIC CONTROL SUSPENSION
seat
, Bracket
O-ring
TSB Revision
INSPECTION
l Check the rubber parts for damage.
l Check the coil springs for crack, damage or deterioration.
Check the shock absorber for oil leakage malfunction and
abnormal sound.
SERVICE POINTS OF REASSEMBLY
12. INSTALLATION OF COIL SPRING
(1) Use the special tool (MB991237 and MB991239) to
compress the coil spring and insert it in the shock
absorber.
(2) Align the edge of the coil spring to the position of the
shock absorber spring seat as shown.
8. INSTALLATION OF BRACKET ASSEMBLY/5. PISTON
ROD TIGHTENING NUT
the figure, tighten the tightening nut to the specified
torque.
(2) Install the coil spring so that the lower edge fits into
the spring seat groove and the upper edge fits into the
spring pad groove, then remove the special tool
2. INSTALLATION OF O-RING/l. JOINT
Apply a coating of rubber grease to the O-ring, install it to
the joint, and then install to the piston rod.
Shock Absorber