Mitsubishi 1989-1993 GALANT Service Manual page 1075

ACTIVE-ELECTRONIC CONTROL SUSPENSION - Height Sensor
Front height sensor connector
terminal array
4
No 1 Sensor A No. Ground
No 2 No. 5
Sensor B Sensor D
No 3 No. 6
Sensor C Sensor power
supply i + 5W
Front height sensor position
Rear height sensor connector
terminal array
4
No. 1 Sensor A No. Ground
No 2
No. 6
Sensor B
Sensor power
No. 3
Sensor C
Rear height sensor position
INSPECTION
l Check the rod and link plate for bending or damage.
l Check the rod adjustment lock nut for looseness.
CHECKING THE SENSOR TERMINAL VOLTAGE
Connect the height sensor to
check that each terminal
table below when, with the ignition key at the ON position,
the sensor's link plate is turned.
NOTE
To check
the sensor terminal voltage, one method which
be used is to move the rod up and down
installed to the chassis.
Front Height Sensor Terminal Voltages
Vehicle height level
Maximum level
Higher than HIGH
HIGH (target height)
Higher than NORMAL
NORMAL (target height)
Lower than NORMAL
LOW (target height)
Lower than LOW
Minimum level
Rear Height Sensor Terminal Voltages
Vehicle height level
Higher than HIGH
HIGH (target height)
Higher than NORMAL
NORMAL (target height)
Lower than NORMAL
LOW (target height)
Lower than LOW
TSB Revision
the body harness and then
voltage changes as shown in the
while the sensor is
Terminal No.
Sensor
link
position 1 2
4.5-5
4.5-5
4.5-5
4.5-5
4.5-5 -
Sensor Terminal No.
link
2
position
4.5-5
can
3