Mitsubishi 1989-1993 GALANT Service Manual page 1114

REAR SUSPENSION <AWD> - Trailing Arm
Pressure fitting Removal
Check bushing for cracks, deterioration and wear.
l
TRAILING ARM BUSHING REPLACEMENT wm
Use the special tool to remove and press fit the bushing.
CONNECTING ROD REPLACEMENT
Replace the connecting rod using the following procedure:
(2) Remove the bolt and nut.
(3) Set the special tool onto the trailing arm as shown in the
illustration.
NOTE
(at the arrow marked "A" in the illustration).
(2) Install bolt B to the trailing arm, at the point shown in
the figure.
(4) Use a spanner, etc., to turn the portion marked "C" in the
illustration to remove the connecting rod.
(5) Installation of the body (special tool) should be performed
with the screw shaft and guide shaft center lines oriented
as shown in the illustration.
(6) zdyly soapy water to the rubber portion of the connecting
(7) Reverse the removal procedures to press fit.
TSB Revision
34-33