Mitsubishi 1989-1993 GALANT Service Manual page 1193

SERVICE BRAKES
INSPECTION BY USING BRAKE FORCE TESTER
NOTE
(1) The brake force tester roller and tire must be dry during the
(2) When testing the front brakes, apply the parking brake and
(1) Place the front or rear wheels on the brake force tester
(2) &(%:he scan tool through the adapter harness (MB991377)
(3) After confirming that the shift lever or selector lever is in
(4) Operate the brake force tester roller.
(5) Depress the brake pedal until the brake force tester
(6) Allow the brake tester indication to stabilize before operat-
TSB Revision
test.
when testing the rear brakes, apply chocks to the front
wheels to lock them.
as illustrated.
the neutral position, start the engine.
(The ABS warning light lights up, it goes into the scan tool
mode. In the scan tool mode, ABS does not function.)
indicates the following value and keep the brake force at
this level during the test.
Front wheels: 800- 1 ,OOON (176 - 220 Ibs.)
Rear wheels: 600 - 800N (132 - 176 Ibs.)
ing the scan tool to perform actuator test (Item No.01, 02,
03). Then, read change of tester indication.
Referring to the following "Judgement in Inspection by
Using Brake Force Tester" table, judge and take corrective
action if necessary.
NOTE
While the ABS is in the fail safe mode, the scan tOOf actua-
tor test cannot be made.