Mitsubishi 1989-1993 GALANT Service Manual page 1107

34-26
REAR SUSPENSION <AWD>
I 4
SERVICE POINTS OF REMOVAL
4. REMOVAL OF CALIPER ASSEMBLY
(1) Remove the lock pin, rotate the caliper assembly
upward, then remove the caliper assembly and secure
it with wire, etc.
Caution
The lock pin has a special grease applied to it, so be
sure not to wipe it off, and ensure that the lock pin
stays clean.
(2) After removing the caliper assembly, cover the guide
pin with a cloth, etc.
8. REMOVAL OF PROPELLER SHAFT' INSTALLATION
BOLT AND NUT
Place mating marks on the differential carrier companion
flange and the propeller shaft flange yoke.
NOTE
The mating marks should be used as a reference for
re-installation.
9. REMOVAL OF SELF LOCKING NUT
differential case with a transaxle jack.
(2) Remove the self locking nuts.
12. REMOVAL OF PARKING BRAKE CABLE AND REAR
SPEED SENSOR INSTALLATION BOLT
sensor installation bolts.
NOTE
The task may be made easier by increasing the gap
between the body and the crossmember.
TSB Revision