Mitsubishi 1989-1993 GALANT Service Manual page 955

ACTIVE-ELECTRONIC CONTROL SUSPENSION - Troubleshooting
terminal) or for air leakage (code No.56) within the front or rear valves.
For malfunctions represented by a code number with the * symbol, if the malfunction is of a temporary nature (such
as improper contact of a connector, etc.), the warning lamp's illumination will stop when the malfunction stops, and
the function will return to normal.
When the alarm light is illuminated (i.e. when a malfunction has been detected), the control mode cannot be
switched (with the exception of a certain few malfunctions) when the control switch is pressed,.
If two or more malfunctions occur at the same time, the corresponding code numbers will be displayed In order from
the lowest one.
Cancellation of malfunction codes after checking and repair (from 1990 models)
Method 1: Connect a scan tool and cancel as described below.
Select "4 SPECIAL TEST" of the scan tool's function-select menu.
Press the YES key when "ERASE DIAG. DODE?" is displayed.
3
4
5 Press the CLEAR key when "FINISHED ERASING DIAG. CODE" is displayed.
Disconnect the scan tool.
Method 2: Disconnect the ground cable from the battery's negative terminal for 10 seconds or longer, and then
reconnect.
If this method is used, note that data entered to the memory of the radio and the clock will be erased,
so readjustment is necessary after the work is completed.
TSB Revision