Mitsubishi 1989-1993 GALANT Service Manual page 1245

35-124
SERVICE BRAKES
Motor relay
Unit <Vehicles with A.B.S.>
SERVICE POINTS OF REMOVAL
6. REMOVAL OF RELAY BOX COVER <RND>
Insert the tip of a screwdriver into the space between the
hydraulic unit and the relay box cover and use it to open
the tab at one place, and then remove the cover.
10. REMOVAL OF HYDRAULIC UNIT
Remove the bracket B, C and D installation bolts, and then
take out the hydraulic unit downward.
Caution
1. The hydraulic unit is heavy, and so care should be
taken when removing it.
2. The hydraulic unit is not to be disassembled; its
nuts and bolts should absolutely not be loosened.
3. The hydraulic unit must not be dropped or other-
wise subjected to impact shocks.
4. The hydraulic unit must not be turned upside down
or laid on its side.
INSPECTION
Check whether there is continuity between terminals when
there is no current flow at each relay and when there is
current flow.
M O T O R R E L A Y
flows between
Between
terminals @ - @
85 - 86
I
I
Continuity