SERVICE BRAKES
Check flow connected with wheel speed
sensor
Is the resistance value of the wheel speed
sensor part, which the displayed diagnos- -
tic trouble code indicates, normal?
Standard value: 0.8-I .2 kQ
Yes
I s t h e resrstance v
connector normal?
Standard value: 0.8- 1.2 kR
Yes
NOTE:
When checking with an oscilloscope. first measure voltage
variations in the wheel speed sensor output. (Refer to
Malfunction of wheel speed
sensor
speed sensor
broken.
g a p b e t w e e n t h e w h e e l
speed sensor and rotor,
which the output diagnostic
trouble
code
within the range?
.
Check the output of each
wheel speed sensor with an
oscilloscope, including the
wave form. (Refer to mea-
surement of wheel speed
sensor output voltage varia-
tions on P.35-69.) Is the out-
put voltage for each wheel
speed sensor over the stand-
ard value and is the wave
form normal?
C a n t h e a b n o r m a l i t y b e
found even if the sensor
harness and connection be-
tween sensor harness and
body harness are bent and
stretched?
All the above checks are _
normal. There is a malfunc-
tion of ABS ECU when this
d i a g n o s t i c t r o u b l e c o d e
reoccurs often.
TSB Revision
sensor.
Repair harness.
indicates,
Yes
Yes
No
R e c h e c k i f b e l o w t h e
standard value or if the
sensor has a poor wave
form. Replace sensor or
rotor.
Yes
and check that the diag-
not reoccur.