Mitsubishi 1989-1993 GALANT Service Manual page 824

/ a s s e m b l y
Inner race
Outer
inner
race
race
PROPELLER SHAFT
(3) If the outer race cannot be removed, remove the
complete Lobro joint assembly from the center prop-
eller shaft by using a commercially available puller.
15. REMOVAL OF D.O.J. ASSEMBLY <A/T>
(1) Remove the D.O.J. boot from the D.O.J. assembly.
(2) Remove the snap ring and then remove the D.O.J.
assembly from the center propeller shaft.
(3) When disassembling the D.O.J. assembly to clean,
etc., first make mating marks with a scriber on the outer
race, cage and inner race, then remove the circlip and
disassemble the D.O.J. assembly.
17. REMOVAL OF BOOT BAND
Caution
Be careful not to damage the Liibro joint boot or D.O.J.
boot when the boot band is loosened.
INSPECTION
Check the propeller shaft splines for wear or damage.
l
Check the ball grooves in inner and outer races for uneven
l
wear, damage or rust.
Check ball surface for rust, wear or other damage.
l
Check the cage for rust or damage.
l
TSB Revision
I
Shaft
I