Mitsubishi 1989-1993 GALANT Service Manual page 1237

SERVICE BRAKES
SERVICE POINTS OF REMOVAL
2. DISCONNECTION OF BRAKE HOSE
Holding the locking nut on the brake hose side. Loosen the
flared brake line nut.
10. REMOVAL OF SELF LOCKING NUT
Using the special tool, secure and hold the rear axle
shaft, and remove the self locking nut.
13. REMOVAL OF REAR AXLE SHAFT
Using the special tool, remove the rear axle shaft.
INSPECTION
Check disc for wear. (Refer to P.35-66, Rear Brake Disc
l
Thickness Check.)
Check disc for runout. (Refer to P.35-66, Rear Brake Disc
l
Run-out Check.)
Check disc for damage.
l
SERVICE POINTS OF INSTALLATlON
1 3 . INSTALLATlON O F
11. COMPANION FLANGE/ 10. SELF LOCKING NUT
(1) Provisionally install the rear axle shaft to the trailing
a r m .
(2) Install the companion flange to the rear axle shaft,
and install the self locking nut.
axle shaft, and tighten the self locking nut.
6. INSTALLAnON OF WHEEL BEARING NUT
After tightening the wheel bearing nut, align with the
indentation in the spindle, and then crimp.
Spindle
Revision
TSB
REAR AXLE