Mitsubishi 1989-1993 GALANT Service Manual page 846

26-16
Lubrication points
Grease: Repair kit grease
120 g (4.2 oz.)
NOTE
The grease in the repalr kit should be
divided in half for use, respectively, at
the joint and inslde the boot.
Snap ring
FRONT AXLE - Drive Shaft (T.J.-R.J. Type)
SERVICE POINTS
4. REMOVAL OF SNAP RING/S. SPIDER ASSEMBLY
( ) Remove the snap ring from the drive shaft with the
I
(2) Take out the spider assembly from the drive shaft.
(3) Clean the spider assembly.
6. REMOVAL OF T.J. BOOT/g. B.J. BOOT
(1) Wrap vinyl tape around the splines on the T.J. side of
Grease: Repair kit grease
120 g (4.2 oz.)
NOTE
The grease in the repair kit should be
divided in half for use, respectively. at
the joint and inside the boot.
OF DISASSEMBLY
snap ring pliers.
Caution
1. Do not disassemble the spider assembly.
2. If the T.J. of the drive shaft assembly is bent, the
joint may be damaged. Use care in handling the
drive shaft.
3. The drive shaft joint uses special grease. Do not
mix old and new or different types of grease.
the drive shaft so that the T.J. and B.J. boots are not
damaged when they are removed.
Caution
Do not disassemble the R.J.
Distinguish between R.J. boot and T.J. boot parts.