Mitsubishi 1989-1993 GALANT Service Manual page 1067

ACTIVE-ELECTRONIC CONTROL SUSPENSION - fi%?d Va've and
7-11 Nm
4-6 Nm
3 - 4 ft.lbs.
Pre-removal Operation
l Removal of Trunk Room Side Tr
(Refer to GROUP 52-Trims.)
Rear solenoid valve removal steps
2. O-rings
8. Rear solenoid valve assembly
9. Rear solenoid valve bracket
Air tube
I
SERVICE POINTS OF REMOVAL
1. REMOVAL OF AIR TUBES
(1) Push the special tool inward,
figure, in order to expand the tabs
(2) Pull out the air tube, together with the special tool. in
direction 0.
Caution
In order to prevent dust, dirt and other foreign
material from getting into the air tube, solenoid
valve and dryer openings. Cover these openings
with vinyl tape or similar material.
(3) For
the joint, and then pull off.
Hold to
prevent NOTE
turning.
When loosening the joint, use a spanner at the
hexagonal part of the joint installation part so as to
prevent it from turning.
Joint
TSB Revision
in direction 0 shown in the
the air tube at the lower part of the dryer,
of the joint.
l o o s e n