34-34
<Reference>
Special tool
REAR SUSPENSION <AWD> - Trailing Arm
(8) Remove the special tool after aligning the holes in
special tool and trailing arm.
(9) Tighten the bolts and nuts to the specified torque.
Tightening torque: 85-l 10 Nm (61-80 ft.lbs.)
SERVICE POINTS OF INSTALLATION
9. INSTALLATION OF REAR AXLE SHAFT/G. COM-
PANION FLANGE/5. SELF LOCKING NUT
(1) Temporarily assemble the rear axle shaft to the trailing
(2) Install the companion flange to the rear axle shaft, then
(3) Hold the rear axle shaft with the special tool so that it
install the self locking nut.
doesn't turn and tighten the locking nut.
the