Half-Fold Position Adj - Konica Minolta bizhub C353 Service Manual

Field Service Ver. 2.0 Jan. 2008
5.1.2

Half-Fold Position Adj.

• The folding position is adjusted by aligning the folding position to the stapling position.
• This adjustment is made in the service mode of the main body. Since the adjustment is
made in increments of 1 mm, this adjustment is useful for eliminating a displacement of
1 mm or more.
• For the effective adjustment of a minimal displacement smaller than 1 mm, refer to
6. Board switch.
See P.52
Adjustment range: - 7 to + 7 mm (Increment: 1 mm)
A. Adjustment procedure
1. Set A3 or 11 x 17 to the Feed Tray.
2. Touch these keys in this order: [Center Staple & Fold] → [OK].
3. Set five sheets of A3 or 11 x 17 original (blank paper acceptable) in the original tray.
• These five sheets are used for adjustment to minimize variation.
4. Press the start key.
5. Check the finished copies for deviation of the stapling position of from the newly folded
position.
Take the top surface of the finished copies as A, and the under surface as B.
Standard: 0 ± 2 mm
<To + side>
A
B
6. Set the mode to the service mode.
See P.338 of the main body service manual.
7. Touch [Finisher].
8. Touch [FN-X3Adjustment].
9. Touch [Half-Fold Position Adj.]
<Standard>
A
B
5. Finisher
<To - side>
A
B
4583fs3502c0
A0D6F3E531DA
39