Table of Contents
Advertisement
Security System
User Guide
Set Part 2 Points (Cmd 65)
I can perform this command.
I cannot perform this command.
Use this command to program which points are armed each time you turn the system Part 2 On. This lets you turn part of
the system on to detect intrusion, while the remaining part of the system lets you move freely without sounding an alarm.
1.
Make sure the system is turned off (On indicator is off).
2.
Press [CMD] [6] [5]. The command center may prompt you to enter a valid passcode.
3.
Enter your passcode if necessary. The command center display scrolls the following:
4.
Enter the Point Number followed by the [*] key to toggle between Yes or No for Part 2 On. Repeat until all
points are programmed Yes or No for Part 2 Mode (Yes = Active, ready to detect intrusion; No = Non-Active,
you can move freely without sounding an alarm).
5.
Press [CMD] to exit this command.
Turn the System On with No Delay
This command turns the system All On or Part On without entry or exit delays. Remember that turning the system on with
no delay allows no exit or entry delay time through the designated delay point, like the Front Door.
1.
Make sure all points are normal (not faulted).
2.
Press [ALL ON] if you want to turn the system All On, or press [PART ON] if you want to turn the system
Part On. Press [CMD] [3] if you want to turn the system Part 2 On. The command center may prompt you to
enter a valid passcode.
3.
Enter your passcode if necessary. The command center display shows the following for turning the system All
On:
Pressing [NO DELAY] begins a 10-sec. "last chance" window in which you have 10 sec. to decide if you want to
allow the system to arm. During this window, the display scrolls through the following messages: No exit
time! System arming. Do not exit! If you decide not to allow the system to arm, enter your
user passcode.
46841D
Pt2 Part 2 No
Front Door
Press 2* for
Pt2 Part 2 Yes
Pt3 Part 2 Yes
Hallway
Press 3* for
Pt3 Part 2 No
To exit
Press Cmd.
60 seconds to
All On.
To bypass points
Press Bypass.
For no delay
Press No Delay.
D623/D625 User Guide
Page 14
© 2003 Bosch Security Systems
Advertisement
Table of Contents
