Cleaning The Internal Components - DataCard SR200 User Manual

Cleaning the Internal Components

Dirt introduced during card feed or burrs caused by friction between the bobbin holder and
bobbin can adhere to the card or film, causing card lamination defects. Clean these components
regularly to avoid lamination defects.
1.
Power off the laminator.
2.
Open the laminator door.
3.
Press and hold down the cartridge release button and pull out the top laminate film cartridge
(LM200 only) and the bottom laminate film cartridge.
4. Use a Datacard® printhead cleaning swab (provided in the Cleaning Kit. Refer to "Cleaning
Supplies" on page
a.
Bobbin holders:
two for each film cartridge
b.
Rear guide rails, on each side of the heat
roller. Clean upper and lower surfaces.
c.
Front guide rails, on each side of the heat
roller. Clean upper and lower surfaces.
5.
Remove any slack in the cartridges.
6.
Reinstall both the top and bottom film cartridges
in the laminator.
7.
Close the laminator door.
SR200 & SR300 Card Printers and LM200 & LM300 Laminators User's Guide
109) to clean the following components:
77