DataCard SR200 User Manual page 108

Printer LCD Message
HR Overheat
TR Heater
TR Overheat
TR Thermistor
RR Overheat
RR Heater
RR Thermistor
Overcool
Head Overheat
Power Intrpt
EEProm Broken
MG Unconnected
98
Possible Cause
The retransfer or bend
remedy roller is too hot.
The retransfer roller is
not working.
The retransfer roller is
too hot.
The retransfer roller
thermistor is not
working.
The bend remedy roller is
too hot.
The bend remedy roller is
not working.
The bend remedy roller
thermistor is not
working.
It is too cold for the
printer to operate.
The thermal head is
overheated.
Power was interrupted
for a short time.
There is an EEPROM
malfunction.
There is a magnetic stripe
module connection error.
Solution
Power the printer off and then on again. Call for
service if the problem persists.
Power the printer off and then on again. Call for
service if the problem persists.
Power the printer off and then on again. Call for
service if the problem persists.
Power the printer off and then on again. Call for
service if the problem persists.
Power the printer off and then on again. Call for
service if the problem persists.
Power the printer off and then on again. Call for
service if the problem persists.
Power the printer off and then on again. Call for
service if the problem persists.
The temperature in the printer area is too low.
Use at the recommended operating
environment temperature as described in
Appendix B: "Site Requirements and
Specifications".
Turn the power switch off and allow the printer
to cool for approximately 10 minutes before
turning power back on.
Power the printer off and then on again. Call for
service if the problem persists.
Power the printer off and then on again. Call for
service if the problem persists.
Power the printer off and then on again. Call for
service if the problem persists.
Error Recovery and Messages