DataCard SR200 User Manual page 112

LCD Message
Overcool
Supply ENC‐B
Wind ENC‐B
Supply ENC‐T
Wind ENC‐T
Other Error
COM Error
102
Possible Cause
The internal temperature
is too low.
A supply side motor
encoder (rotation
detection) error has
occurred.
A take‐up side motor
encoder (rotation
detection) error has
occurred.
A supply side motor
encoder (rotation
detection) error has
occurred.
A supply side motor
encoder (rotation
detection) error has
occurred.
An undefined error has
occurred.
A communication error
has occurred between
the printer and the
laminator. The power of
the laminator is off.
There was a
misalignment in the
positions of the laminator
and the card printer.
Solution
The ambient operating temperature is too low.
Use the laminator within the prescribed range.
When starting up the laminator in a low
temperature environment, the temperature of
the interior can remain low even though the
surrounding temperature has gone up. Power on
the laminator again after waiting for about one
hour.
Power the laminator off and then on again.
Contact your service provider if this does not
correct the condition.
Power the laminator off and then on again.
Contact your service provider if this does not
correct the condition.
Power the laminator off and then on again.
Contact your service provider if this does not
correct the condition.
Power the laminator off and then on again.
Contact your service provider if this does not
correct the condition.
Power the laminator off and then on again.
Contact your service provider if this does not
correct the condition.
Power on the laminator.
Fit the laminator and printer to the joining plate
properly. Refer to the Installation Guide for more
information.
Error Recovery and Messages