Suggested Laminator Settings - DataCard SR200 User Manual

Laminator Red Status
Status Light
Ready Off
Laminating Off
Error mode Blinking
(Slow)
Blinking
(Fast)
Roller cleaning Blinking
in progress (Slow)
Download On
mode
Downloading Blinking
(Fast)

Suggested Laminator Settings

You can view or change Laminator settings by using the Laminator tab of the Status Monitor.
(Refer to "Laminator Tab" on page
The proper laminator settings depend on the side(s) of the card being printed and the side(s)
being laminated. The following tables show examples of settings to use. These settings assume
that you use PET‐G cards, and operate the printer and laminator within the environmental
specifications. Make changes in small steps and test the results.
SR200 & SR300 Card Printers and LM200 & LM300 Laminators User's Guide
Blue Status Card Printer
Light LCD Panel
On Ready
Blinking Laminating
(Fast)
Off Error message
Off Error message
Blinking Cleaning
(Slow)
On Download
Blinking Downloading
(Fast)
47.)
Description
The laminator is ready.
Lamination in progress.
Errors that do not require the
laminator to power off and then
on. Refer to "Error Messages" on
page 95.
Errors that require the laminator to
power off and then on. Refer to
"Error Messages" on page
Cleaning is in progress. Returns to
the original state if a cleaning card
is not inserted within a specific
time interval.
Waiting for download data, or
process has ended.
Downloading data. (The blinking
speed is faster than when
laminating is in progress.)
95.
69