Laminator Tab - DataCard SR200 User Manual

Laminator Tab

The Laminator tab is enabled if a laminator is connected to the printer. Use the settings to adjust
lamination for best results. Refer to "Suggested Laminator Settings" on page
settings for single‐sided and double‐sided lamination.
The Laminator tab displays:
Basic Settings:

Laminate Mode:

Select Laminate to laminate a card.

Select Pass Through to skip lamination.

HR Control:

Read‐only. Displays Enable if HR Control is

enabled on the Printer Setting tab. When
enabled, the temperature of the laminator heat
roller is lowered when the printer and laminator
are not used for 30 minutes or longer.
This setting works with the card printer setting (refer to "Printer Setting Tab" on

page
the laminator into standby mode if you will not be printing cards for a long time.)
Cleaning Counter: Displays how many laminations have been performed since the last

roller cleaning.
Bottom and Top Side Settings:

Cassette Status field: Displays Cassette is Detected or No Cassette.

Film Type: Patch or Overlay. Refer to"Laminator Material" on page

information.
Patch position: Refer to "Adjusting the Patch Position" on page

Heat roller temperature setting: Sets the temperature for the laminator heat roller.

Common Settings:

Speed: Sets the card speed during lamination.

Cooling Time: Sets the standby time for cooling down the card before lamination starts.

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User's Guide
42). This is always set to On automatically when overlay film is selected. (Put
69 for examples of
106 for more
93 for more information.
47