3.
Press the cartridge release button and pull out the film cartridge. The cartridge may be
difficult to pull out if the card is stuck to the laminate film. Pull out the cartridge slowly to
avoid dropping the laminate film from the cartridge. If the cartridge cannot be removed, call
for service.
4.
Remove the jog dial from the card printer and attach it to the jog dial insertion slot.
5.
Turn the jog dial counterclockwise to discharge the
card from the card outlet.
6.
Inspect the cartridge:
If the material on the cartridge is in one piece:
Turn the bottom‐side cartridge take‐up knob counter‐
clockwise until all damaged material is wound neatly on
the take‐up spool.
Turn the top‐side cartridge take‐up knob clockwise until
all the damaged material is wound neatly on the take‐up
spool.
If the material is split or broken:
Trim the ends of the broken portions evenly.
Align the end of the supply material with the take‐up
spool and apply tape to secure it.
Turn the material onto the take‐up spool until the
mended portion is wound two or three turns.
7.
Replace the loaded laminator cartridge in the printer until it
clicks into position.
8.
Close the laminator door. The laminator reinitializes automatically.
92
Take-up Spool
Tape
Error Recovery and Messages
Supply Roll