Cleaning The Printer; Cleaning The Cleaning Unit; Cleaning The Card Load Roller - DataCard SR200 User Manual

Cleaning the Printer

This section provides information regarding proper care and cleaning of the printer. It also
includes recommendations about how often to clean and replace components.
Recommended cleaning supplies are listed in Chapter

Cleaning the Cleaning Unit

The cleaning unit is located inside the printer door. It cleans lint
and other debris from the cards before printing. To clean the
unit:
1.
Open the printer door.
2.
Pull the cleaning unit out.
3.
Wash the blue cleaning rollers with water. Rub rollers
gently under running water. Do not use isopropanol or
detergents to clean the rollers.
4.
Allow the card cleaning rollers to dry thoroughly.
5.
Reinstall the cleaning unit with the blue rollers facing to the
right.
6.
Close the printer door.

Cleaning the Card Load Roller

The card load roller is located under the card hopper and
picks cards before they are printed.
1. Remove the card hopper. Refer to "Removing the
Card Hopper and Cards" on page
2.
Using a cleaning wipe with isopropanol, wipe the
roller while pushing it toward the printer.
3. Replace the card hopper. Refer to "Replacing the
Card Hopper" on page
72
13.
14.
7: "Supplies" in this User's Guide.
Maintaining Your Printer and Laminator