Checking the Laminator Connection
When using the LM200 or LM300 laminator, make sure that:
The printer and laminator are aligned at the infrared ports, using the joining plate.
The power cord is securely connected to the laminator and an appropriate grounded power
source.
Supplies are loaded and the laminator door is closed securely.
Powering On the Laminator
When the LM200 or LM300 laminator is used, power on the laminator
before powering on the printer.
1.
Press the laminator power switch.
2.
Make sure that the laminator is ready before proceeding to power
on the printer:
The printer LCD panel displays Initializing and the blue status
indicator light blinks.
Preheating displays on the printer LCD panel for approximately
four minutes while the heat roller warms to operating
temperature.
The laminator material initalizes automatically.
The printer LCD panel displays Ready and the blue status light is
lit when the laminator is ready to process cards.
20
Blue Status Light
Power Switch
Using the Printer and Laminator