Site and Usage Guidelines
When choosing a site for the printer and its supplies, consider these guidelines:
Keep all dust, dirt, food, liquids, etc. away from the printer at all times.
Keep paper and foreign materials off the printer.
Place the printer on a stable platform; keep it off the floor.
Do not place in areas susceptible to strong vibration or shock.
Place the printer away from direct sunlight.
Place the printer away from heating ducts, blowers, or other air vents.
Do not use the printer for purposes other than its intended use.
When cleaning around the printer, prevent debris from entering the printer.
Place the printer in a clean office environment, protected from any type of construction.
Store all supplies in the original packaging until you load them in the printer. Keep the
original packaging closed.
Store all supplies in a clean, cool, and dry location.
Do not use supplies or cards that have been dropped on the floor or have otherwise become
contaminated.
Keep the printer powered off and covered when not in use.
Operating Environment
The performance of the printer and laminator is strongly influenced by the installation location.
Using the printer in areas that are cooler than the recommended temperatures can cause
retransfer errors. Using the printer in areas that are warmer than the recommended
temperatures can cause errors such as card warping and retransfer film errors.
Consider the following recommendations if you need to move or relocate your printer.
Temperature: 59°– 86°F (15°–30°C), or 63°–83°F (17°–28°C) if using peel‐off (PO) or UV ink.
Relative humidity: 35%–70%, non‐condensing, or 35%–60% if using peel‐off or UV ink.
B-2
Site Requirements and Specifications