Printer Settings; Encode Tab; Laminate Tab - DataCard SR200 User Manual

Printer Settings

On the Print tab, the "Enable printer settings" feature is available for administrator‐level users.
Refer to "Configuration Tab" on page
open the Settings dialog box. The Settings dialog provides a convenient location to manage
settings provided on several tabs in the Status Monitor. Refer to"Printer Setting Tab" on page
the "Retransfer Tab" on page 43, or the "Bend Remedy Tab" on page
about the available settings.

Encode Tab

The Encode tab contains settings for using smart card
(IC) and magnetic stripe encoding. (Your ID software
might specify these settings, which override the
Encode tab.) You can also specify whether to turn
over the card after an encoding step.
Only options installed in the printer display in this
tab. Refer to Chapter
on page 81 for more information about encoding
magnetic stripes.
Refer to the Datacard SR200 & SR300 Plug‐in User's
Guide for information on using Datacard ID software
applications to encode magnetic stripe onto cards.

Laminate Tab

The Laminate tab contains mode settings for the laminator,
if one is used. Three modes are available:
Default: Operates using the settings defined in the

Laminator tab of the Status Monitor.
Pass Through: Does not laminate the card.

Laminate: Laminates the card.

36
37 for more information about this setting. Click Settings to
5: "Magnetic Stripe Encoding"
44 for more information
Printer and Laminator Settings
42,