Printer Setting Tab - DataCard SR200 User Manual

Printer Setting Tab

The Printer Setting tab displays:
Controls for viewing or changing print settings:

YMC Ink Print Level. Sets the print density for color

printing. Select from seven gradations from ‐3
(lighter) to +3 (darker).
Resin K Ink Print Level. Sets the K resin ink print

density. Select from seven gradations from ‐3 (lighter)
to +3 (darker).
UV Ink Print Level. Select from seven gradations from

‐3 (lighter) to +3 (darker).
Peel Off Ink Print Level. Select from seven gradations from ‐3 (lighter) to +3 (darker).

Resin K Ink Print Mode. Sets the K resin ink print quality. If Fine is selected, the print

quality improves but the printing speed is slower. Change to Fine if thin lines or small
black text is blurred on the cards.
MG Peel Mode. Select MG Stripe for the printer to use peel off ribbon in the magnetic

stripe area (if installed).
Standby Mode. Pauses the card after printing and before transferring the card to the

laminator.
Back Side Cooling. Select Enable to cool the card when printing on both sides of the card.

Controls for viewing or changing magnetic stripe settings:

Number of Retry. Sets the maximum number of retries when writing or reading magnetic

stripe data fails. Default value is 1.
ISO Mode. Sets the power used by the magnetic card encoder. The default is Hi‐Co.

JIS Mode. Sets the power used by the magnetic card encoder. The default is Hi‐Co.

Controls to set power saving capabilities:

Power Saving Interval: Select the interval to wait until power saving takes effect and the

printer goes to sleep. Select Off for network operation or select from 5 to 60 minutes for
a USB connection. The default is Off.
When the printer goes into power save mode, Sleeping displays on the LCD panel.
To cancel power save mode, press Reset and then the
HR Control: Select Enable to lower the temperature of the retransfer heat roller when

printing is not performed for 30 minutes or longer. When enabled, heat roller
42
(Return) key.
Printer and Laminator Settings