Laminator Status And Settings; Displaying Laminator Status On The Lcd Panel - DataCard SR200 User Manual

Laminator Status and Settings

If an LM200 or LM300 laminator is used with the card printer, its status can be displayed on the
printer's LCD panel. Recommended laminator settings are listed in this section.

Displaying Laminator Status on the LCD Panel

The printer LCD panel can display the status of the laminator.
Follow these steps to display the laminator status:
1.
Press the Menu key.
2.
Press the Next key until Setting is displayed. Press Enter.
3.
Press Enter to open the Display menu. Mode ‐ Counter is
displayed.
4.
Press Change.
5.
Use the down arrow key to change the mode to Laminator State. Press
6.
Press Exit three times to exit the menu system. The laminator status is now displayed on the
printer LCD panel.
This table describes each laminator status as displayed on the PC status monitor and LCD display,
It also indicates the condition of the laminator status lights and printer LCD panel for each status:
Laminator Red Status
Status Light
Initializing Off
Preheating Off
Low Off
temperature
standby mode
Power saving Off
mode
68
Blue Status Card Printer
Light LCD Panel
Blinking Initializing
(Slow)
Blinking Preheating
(Slow)
Blinking Standby
(Slow)
Blinking Sleeping
(Slow)
(Return).
Description
Initializing in progress.
Adjusts the heating roller to the
preset temperature.
In HR control mode.
Low power standby mode.
Operates together with the card
printer settings.
Printer and Laminator Settings